cylinder heads
oven bake & steelabrate                  54.00
magnaflux                                        35.00
replace guides                               144.00
install hardened seats                    112.00
valve job                                         135.00
resurface heads                               75.00
install freeze plugs                             8.00

Block
pre-clean                                          45.00
oven bake & steelabrate                  85.00
re-surface deck                              150.00
align-hone                                      165.00
bore and hone with torque             240.00
plates ( street finish )
install cam bearings                         75.00
install galley & freeze plugs              33.00
modify oil passages                          85.00

Rods
oven bake & steelabrate                  28.00
re-size big end ( w/ARP )                224.00

Pistons
press off old and refit  new               80.00

Crankshaft
oven bake & steelabrate                  22.00
chamfer oil holes                              30.00
custom grind                                  155.00
balance assembly                          255.00

Labor
disassemble engine                       150.00
assemble                                        990.00
dyno break in and tune                  550.00

Total machine work & labor         
3925.00  
New Parts
16 - 7000 series cast guides                       28.80
8 - 30,000 series hard seats                       66.00
set - new valves                                        129.95
set - new valve springs                               36.00
& locks
8 - intake seals                                           15.12
set - rocker assemblies                             169.95
16 - new push rods                                     32.95
master engine kit  (includes )                    748.70
pistons, rings, bearings, gaskets
brass freeze & galley plugs, oil pump kit
Stage 1 plus cam, lifters, tru roller timing set


8 - RTS-44ts spark plugs                            16.95
oil, filter, paint and materials                       95.00
Parts total                                               1339.42

total including
machine work, labor and parts             $5,264.42

This price does not include core, crating, shipping
or applicable sales tax

With stock intake and Quadrajet this combination
has 8.5 compression, idles well and will make over
250HP and will run on
unleaded  87 octane pump gas

We have included as standard in this combination
extras such as brass freeze plugs, hardened
exhaust seats, ARP rod bolts, enhanced oiling,
balancing, blueprinting,
dynamometer break-in and tune
Effective 1-1-2013

Price subject to change do to increase in costs
Street 1   
250 + HP
350 Buick

manganese bronze valve guides             101.20
will last thousands of miles longer

oil pan baffle (includes installation)             8.00

T/A intake                                                359.95
includes stainless intake bolts

Intake oil shield                                          35.00



Q-Jet Carb rebuild includes parts                    285.00
And recalibrate for larger cam  
(PLATING AVAILABLE)

New MSD stand alone distributor                     369.72
MSD blaster coil                                                 43.95

rebuild point distributor                                    189.95
Includes new points, condenser, cap, rotor
vacuum advance and harness

rebuild point distributor                                    257.90
Includes
new Crane Fireball electronic conversion,
cap, rotor, vacuum advance and harness

rebuild HEI distributor                                     225.00
includes new magnetic pick-up, module,
wiring harness, cap, rotor and coil

7mm wire set                                                     39.95

custom Buick 8 mm wire set                             159.95
include wire separators and hold downs
Street 1 options
Click here for pictures of 350 Buick machine work